You are viewing an old version of this page. View the current version.

    Compare with Current View Page History

    Version 1 Next »

    On the Supervisor, with the QubeGUI, perform the following checks:

    1. Verify Supervisor is running –Confirm that the title bar shows it can connect to the Supervisor.
    2. Verify license is installed – Check the QubeGUI title bar to see that the proper number of licenses are available. If the license is not properly installed it will show 0/2 (or 1/2, 2/2). If this is encountered, see the License Installation section to install or reinstall the license.
    3. Verify Workers are registered – Click on the Host Layout and check that all the expected Workers are listed. If they are not. There may be a firewall issue (see Disabling the Firewall section) or the Supervisor hostname was not specified for the Worker and it is not on the same subnet (see configuration under Worker Installation).
    4. Verify jobtypes (backend) are installed on Workers – Click on the Workers and look at the Properties Panel for the "Jobtypes" list at the bottom. Confirm that all jobtypes that use backend scripts (not cmdline or cmdrange through the SimpleCmd interface) are listed.
    • No labels